this video might help:
hi steven,
were you able to test again?
Diving into it right now. Will get back to you soon.
Hi Synthia,
Thank you for your continued assistance. I’ve run into a number of stumbling blocks and would appreciate clarification.
- I understand that I am to output the remote vocal on Track 1 to the Scarlett and not the master channel. However Scarlett is the master channel on my system. So where should I route Track 1’s output?
- I’m quite confused about Trk 2 instructions. Why do I need to use Trk 2 for playback? Once recorded, my waveform will of course show up on Trk 1. So you mean I should copy and paste that waveform to Trk 2 for playback? And where should its output be assigned?
- For Trk 3, you stated its output should go to BH channels 1/2 and Scarlett 1/2. By that you mean my aggregate output, right?
- In local JackTrip I attempted to set my JackTrip to Output to Aggregate Chs 5-6, only to discover the only available output channels on the aggregate device are 1/2 or 3/4.
Thanks again for your help.
Steve
fine to use 3/4, but please just start a new test project and follow my
instructions to the letter.
Nevermind the 4th item in my most recent email. I have two blackhole drivers, a BH2 and BH16. I just needed to route through the BH16. No longer an issue.
1 Like
let’s take this to the messaging so that folks do not get confused. 
Hi all … i use jacktrip with a thunderbolt UA interface and macOS
And yes i use too „loopback Audio“ and „blackhole16ch“ together with Luna
Here are my screenshots
1 Like
What a beautiful interface Luna is! Thank you so much @florit for sharing this with us. I wanted to share your post to the “Share Your Setup” subcategory, but just learned that a post can have only one category so I will leave it in the General Discussion until I figure out a better way to do it. Thanks!
1 Like
Yes share the post … I’m happy about hearing this